How can I make my own carbonated fruit drinks at home?
Make a pectin-free fruit juice, sweeten and acidify it to taste, chill it very cold and carbonate it, either in a whipping siphon with CO2 cartridges or by mixing a fruit syrup with sparkling water. Cold liquid holds CO2 much better. Soda-maker manuals say to carbonate only water, so follow your device's manual.
Free download
Juice, Soda and Water Storage Chart (PDF): How long juice, soda, coconut water and bottled water last, opened and unopened. 19 rows, each with its source.
Thank you
Your chart is ready
We use your email only for this download.Also free:
Home Bar Storage Chart (PDF)Milk and Dairy Storage Chart (PDF)Coffee, Tea and Hot Drinks Storage Chart (PDF)Drink Strength, Calories and Units Cheat Sheet (PDF)Want the full pack? About 10 printable sheets: a larger chart for each drink type, a “has it gone off?” checklist, date labels, a party planner and an inventory sheet.
In this article
What is the easiest way to make a fizzy fruit drink?
Mix a fruit juice or syrup with sparkling water. It needs no special equipment beyond a bottle of seltzer or a soda maker used only for plain water. Use about one part juice or syrup to two or three parts fizzy water and adjust to taste.
How do you carbonate juice itself?
A food site describes using a 1-liter whipping siphon with CO2 cartridges. The steps it gives are:
- Make a pectin-free juice, season it with sugar, a little acid and a little salt, and chill it.
- Fill the siphon with about 2 1/4 cups of seasoned juice and add about 2/3 cup ice (skip the ice for very light juices such as watermelon or orange and use an equal mass of juice).
- Charge with one cartridge, hold the siphon upright and release the gas to vent the air.
- Charge with two more cartridges and shake until the ice melts and the liquid is cold.
- Release the pressure with the siphon upright before opening the cap.
The article notes that venting air first matters, because compressed air is not fizzy, and that CO2 dissolves best in ice-cold liquid, so a flat result usually means the juice was not cold enough.
What ratios does it suggest?
For seasoning it gives typical ranges: malic acid 0.3 to 0.5 percent of juice weight, fructose 8 to 14 percent and salt 0.05 to 0.1 percent. These are starting points; taste and adjust. Phosphoric acid is also listed, but you can skip it at home.
Which fruits work best?
The source calls for a pectin-free juice. Strained, clear juices are the safest start; pulpy or thick juices can foam and are harder to carbonate, so strain them first.
Is it safe?
- Many home soda makers are designed for water only. Manufacturer manuals we saw say to carbonate only plain water and add flavor afterward, because other liquids can clog parts; check your manual.
- Never overfill a bottle or siphon.
- Open pressurized containers slowly, pointing away from people.
How long does it keep?
Treat fresh homemade drinks like fresh juice: keep refrigerated and drink within a few days. Fizz fades quickly after opening.
People also ask
Can I put juice in a SodaStream?
Most soda makers are designed for plain water, and manuals say to add flavor after carbonating. Check your manual first.
Why is my homemade soda flat?
Usually the liquid was not cold enough, since CO2 dissolves best in ice-cold liquid, or air was not vented before charging a siphon.
What is the simplest carbonated fruit drink?
Fruit juice or syrup mixed with sparkling water, about one part to two or three parts.
Sources
About · How we verify this · Editorial policy · Corrections
What would help you most next?
One tap. Anonymous. It helps us decide what to build.
Thank you. The free charts above are yours to keep.



